USING THE GENIUS REMOTE TO LEARN ADDITIONAL
FUNCTIONS FOR CLU-850GR
Storing Operation
®
Set the remote transmitter as shown below.
Put the remote transmitter which contains the codes to be stored and the GENIUS REMOTE transmitter to face each
other. (Distance should be 2-4 inches.)
®
B!2 El
O ollOOOOll
-4_nches _cl
_oi
i(@D_,®_e_,,_ ° _
O
IlOOO011
<
>
_
_'@
=_
n
O n
IiO
oloII
i01
_o_ p e ,___,o o
•
I
/
i
Remote controlto be stored
GENIUS remotecontrol
_)
Set the LEARN/USE mode select switch located on the back of the Genius Remote to the LEARN position.
Set the MULTI-PAGE select switch to =USER" position.
Press one of the learnablebuttonson the Genius Remote, ("7" in this example).This buttonwill be used to store
the new code. The READY indicatorwillflash at this time. (The lightwill remainlit for approximately15 seconds.
If no otherfunction isperformedat this time, the operationis canceled.)
READY
LEARN
(flashing)
(off)
The Genius Remote is ready to receive an infrared code
from another remote.
_)
Press and hold the button down on the other transmitter which contains the code to be stored, while the READY light
is flashing on the Genius Remote.
Release the button after both the READY and LEARN indicators light and then go off.
39