Royal Vacuum Cleaner Owner's Manual page 7

TOOL REQUIRED: PHILLIPS SCREWDRIVER
Aligntabson tool caddy
with slotson midsection
and snap intoplace,
nut i nto recess _Icaddy and hold
,Iace ( Diagram 2)Press handJe reiease
your o ther h and t otiltthemidsection
backwards (Diagram 2a),
Place screw through center of
lower midsection and tighten
k_---/J t loseClipl ! ld'flt.l_Lt_ll _ _ 1+-'! ! /A_,i_/.,_ tl "4
_._/"
.../Upper
Lowerl-l!!o._y : ,-,1 t L,. M .IJ I //1 !!ffr IF I€ I
_._ cordI cord _/--_ c3 1 _.I_ _ 1 //.2:a I1-11 _ I v I
_J Clip l Clip I t_ tl 11"-"g__e.tY 7 l /! lllttl-7_l Ilol I
_'_"1__-._ l 1" I_i -- IU I I I! " T_d " f3;[ i II IIJ_X',llflll _ L I
Wrap the cord around the upper and lower cord Slide the UphotsterytStair Clipthe adapterend of the
clips, AttachmentInto the middle hose into the slot on the
slot of the lowertoo! caddy+ lowertoot caddy,
Run the hose to the
upper caddy and press
Into hose clip #1 (See
diagram 4)
Continue wrapping the
hose clockwise around
thetool caddies,pressing
the hose into the groove
on the bottom of the
lower tool caddy
* Not available on aft models
l
7
Loci{ the attachment
,nd of the hose into
lip #2 p_pressing down
). ,._/"_nto the ibo4tlocated on
_ t_e right side of the
1 lowht.rtool 4addy, until
/ secure