GE JV347 Owner's Manual And Installation Instructions page 12

Installation Instructions
[] MARK HOLES
Select the _ent option that _our installation will
require and proceed to that section:
A. Outside top exhaust
(Vertical duct-31/4" x 10" Rectangular)
• Use the diagrmn or the hood as a template and
mark tile locations on tile cabinet for ductwork,
electrical wiring and keyhole screw slots.
Hoodmountingscrews(4)
133/4" ( 30" hood)
16W' (36" hood)
133/4 " (30"hood)
163/4' ' (36"hood)
Wood shims
recessed-bottom cabinets Center
only shims must bea ne
minimumof 3/0" thick
andcut to fit tile width
of the innerrecessed
cabinetbottom}
Electricalaccesshole
(in cabinetbottom)
B.Outside top exhaust (Vertical duct-T' Round)
• Use tile diagram or tile hood as a template and
mark tile locations on tile cabinet for ductwork,
electrical wirin(* and kexhole screw slots.
Hoodmountingscrews(4)
133/4" ( 30" hood) 13¾"(30" hood)
hood) hood)
front
"_ Cabinet _-- 7v¢' --"
bottom
Access _ 11/4"
\ round duct -- o
\ T ¥
Electrical a ccess
hole
(in cabinetbottme/
+
Wood shims
(recessed-bottom cabinets
Center
only shirosmust be a mioiroum
line
of 3/8" thickand cut to fit the
width of the inner recessed
cabinet bottom)
C. Outside rear exhaust
(Horizontal duct-31A" x 10" Rectangular)
• Use tile diagram or tile hood as a template and
mark tile locations on tile cabinet for ductwork,
electrical wiring and keyhole screw slots.
Wood shims
(recessed-bottom cabinets onIwshims must be a
miniroumof 3/0" thick andcut to fit the width
of the inner recessedcabinet bottme)
[__abinet front
I/zU
11A- , II
/_'l _* 3gt" Hodzonta, duct T(_)-
/ I . __j access h _le ] 1_.
rCaNnet , I "
\ [bottom
1_-51/4 " -,-,-6'/_" _ I
<- 7Y4"
\ _-- 13¾" (30" hoed) --) <-_ 133A" ( 30" hood)
-- 163/4 " (36" hood) 163/4 " (36" hood)
Electrical a ccesshole
Hoodmountingscrews(4) Centerline (inwall)
D.Recirculating (non-vented ductless-
JN327 and RN328, and optional on
JV347 and JV367 models only)
" Use the hood as a template and mark tile locations
on tile cabinet fl)r the electrical
wiring and keyhole
screw slots.
, Since tile hood is to be recirculated (not to be vented
outside), do not cut out am vent ol)enings, in tile wall
or cabinet bottoln.
[] CUT HOLES
Cut holes at marked locations for duct and electrical
wiring. For the vertical duct, ('/it ()/it
3/4"
extra
toward tile fl'ont of tile cabinet so you can move tile
duct fl'eely when installing the hood. It may also ease
installation by cutting the hole 10½" instead of 10".
[] RUN WIRES
Rtm tile electrical wires through tile wall or
cabinet according to National Electrical Code
and applicable local codes.
NOTE: DO NOT turn tile power on until
installation is complete.
12