GE JV347 Owner's Manual And Installation Instructions page 10

Installation Instructions
[] REMOVE EXHAUST ADAPTOR
If exhausting/venthlg using the 3¼" x 10" rectangular
duct---optional for JV338, Jv347 mad Jv367 models
tufty:
]_.elnove the exhaust adaptor fl'Oln the inside of the
hood. Set it aside along with its mouI]tiI]g screws.
374"x 10" -
rectangular
exhaust
adaptor
andscrews
CD
[] REMOVE FILTER
]_.eulove the shippiug tape holdiug the metal grease
filter in place. Pull down on the center of the fl'ont
edge of the filter. The filter will then slip out of the
retailfing tabs on the back.
Metal grease filter
[] REVERSE THE BAFFLE FOR
DUCTED INSTALLATIONS ONLY
(JV347 and JV367 models)
If the hood is to be recirculated, skip to the next step.
]_emove the baffle fl'om the top of the hood. Re-install
the baffle so the short side Inarked "VENTED" is
visible. The long side of the baffle should be inside
the hood.
"VENTED" i s visible
[]REMOVE WIRING COVER
Remo_e the wiring cover ti'om inside the hood,
Set the cover and its mounting screw aside.
Wiring
[] REMOVE WIRING KNOCKOUT
Remoxe either the top or the back wiring knockout as
needed and install an approxed strain relief clmnp.
Topknockout Backknockout
Strain relief
Strainrelief
clamp
[] REMOVE DUCT KNOCKOUT
If recirctflating, uou-',euted ductless (IN. 2 iaud RN328,
and optional I0r.[V347 and.IV367 inodels Olfly), skip to
Step 10 D and proceed.
Using a fiat blade screwdrivei; relnove the appropriate
duct knockout fl'Oln the top or back of the hood.
3'/4"x 10" Rectangular
vertical discharge.
Remove top rectangular
duct knockoutonly.
7" Roundvertical
discharge. Remove circular
duct knockoutonly.
3Vg'x 10" Rectangular
horizontal discharge.Remove
rearrectangularduct knockoutonly.
10