GE JBP29G Use And Care & Installation Manual page 33

Leveling the Range
For proper cooking and baking the
range must be leveled° Leveling
legs are located on each corner of
the base of the range_ Remove the
bottom drawer and you can level
the range on an uneven floor.
To remove the drawer, pull the
drawer out all the way, tilt up the
front and take it out. To replace the
drawer, insert glides at the back of
the drawer beyond the stop on the
range glides° Lift the drawer if
necessary to insert easily_ Let the
front of the drawer down, then push
in to close°
1/8%i.imom
One of the rear leveling legs will
engage the ANTI-TIP bracket (a!low
for some side to side adjustment).
Allow a minimum clearance of t/8"
between the range and the leveling
leg that is to be installed into the
ANTI-TIP bracket.
Spirit
Level
Install the oven shelves (see use
and care section for instructions).
Put a spirit level or a glass
measuring cup partially filled with
water on one of the oven shelves,
- _
Range
Lee
Leveler
Raise J _"
Range
Use a 1¾" open end wrench or an
adjustable wrench to equally back
out the four leveling legs two or
three turns each. Now use the
wrench to adjust the leveling legs
until the range is level.
33