Table of Contents
Advertisement
Anti- ip Bracket Installation Instructions
for Bracket Kit No. 342473
WARNING
,, ALL RANGES
CAN TIP
- INJURY
COULD
RESULT
• INSTALL
ANTI-TIP
BRACKET
PACKED
WITHRANGE
• SEE INSTRUCTIONS
Tools Needed
o Phillips head screwdriver
" 1¾" or adjustable
wrench
Bracket attaches to floor or' wall to
hold either fight or left rear' leg
leveler. If fastening to floor, be sure
that screws do not penetrate
electrical
wiring or plumbing.
If
this cannot be determined,
use
shorter screws that will not
penetrate
through flooring,.
If the bracket came with your range,
it is shipped attached to the lower
range back. Remove and discard
the shipping screw that holds the
bracket and then follow instructions
be!ow.
1. Decide whether the bracket will
be installed on the right or left side
of range location.
Adjacent cabinet or final
location of range side panel
Outside edge of bracket to be
flush with left or right side
of range
Fig, 1
l
Screwmust enter wood or metal _
----,.
I_ |
/
Fig, 2
_
:'_
2. If the bracket side of the range is
adjacent to a cabinet,
place the
bracket against back wall and
cabinet as shown in figure 1.
If there is no adjacent cabinet,
determine
where the location of the
range side (painted outside panel)
will be. Place the bracket with its
outside edge at this location and
against back wallo See figure 1.
3. Determine
whether you will
anchor the bracket to the floor or to
the wall as shown in figure 2.
Fasten the bracket securely with
the screws provided.
Screws are
self-drilling
in wood, plywood,
particle and chip board, and most
metal framing° If attaching to
masonry you can buy suitable
screws and anchors at hardware
stores° Use a masonry drill to drill
the required
holes.
4. Using the wrench, back out the
four leg levelers at least two tuins_
See your installation
guide for
more leveling information
before
positioning
range.
5. Slide the range into place. Be
sure rear leg leveler fully engages
slot in bracket.
If range cannot be
moved back far enough for rear leg
leveler to enter bracket,
move
bracket forward as required and
attach to floor in new location.
30
Advertisement
Table of Contents
