Ovenshelves - GE JBP29G Use And Care & Installation Manual

Care and Cleanh
Proper care and cleaning are
important so your range will give
you efficient and satisfactory
service. Follow these directions
carefully in caring for your range to
assure safe and proper maintenance.
Porcelain
Enamel Finish
The porcelain enamel finish is
sturdy but breakable if misused.
This finish is acid-resistant,. However,
any acid foods spilled (such as fruit
juices, tomato or vinegar) should not
be permitted to remain on the finish.
Glass Top
(on models so equipped)
The glass on your range has
been tempeled to withstand sudden
temperature changes during
cooking_ Give it the norma! care
you would give any glass material.
WhAle it is impact-resistant,
avoid scratching it to prevent it
from shattering.
If the glass around the solid disk
elements is hot, wipe up spills with
a dry cloth or paper towel° When
the surface has cooled, wash, rinse
and dry it. Alternately, when the
glass top is cool, spray it with glass
or window cleaner, Avoid the use of
cleaning powders or harsh abrasives
that may scratch the surface°
Broiler Pan & Rack
After broiling, remove the broiler
rack and carefully pour off the
grease. Wash and rinse the pan and
rack in hot, soapy water,
If food has burned on, sprinkle
the rack while hot with detergent
and cover with wet paper towels or
a dish cloth. That way, burned-on
foods will soak loose while the meal
is being served.
Do not store a soiled broiler pan
and rack in the oven. Do not clean
in self-cleaning oven.
OvenShelves
Oven shelves may be cleaned with
a mild abrasive cleanser following
manufacturer's directions, After
cleaning, rinse the shelves with
clean water and dry with a clean
cloth.
To remove heavy, burned-on soil,
soapy metal pads may be used
following manufacturer's directions_
After scrubbing, wash with soapy
water, rinse and dry°
Cooktop Light and Starter
(on models so equipped)
Canopy Bulb
Starter
Do not touch the bulb when it
is hot or with wet hands. Never
wipe the light area with a wet
cloth. Electrical power must be
shut off if you have to replace a
broken bulb.
To replace bulb:
1. Flip front of the hinged canopy up.
2, Remove fluorescent light bulb.
Replace the bulb with one of the
same length and wattage.
3. Lower the canopy.
To replace starter:
1. Open canopy and remove bulb
as explained above.
2, Grasp starter, turn it
counterclockwise, about one
quarter turn and lift out. Replace
with one of the same wattage°
3. Reposition bulb and lower the
canopy.
Oven Light Bulb
The light bulb is located in the
upper right corner of the oven.
Before replacing the bulb,
disconnect electric power to the
range at the main fuse or circuit
breaker panel or unplug the range
from the electric outleL Let the
bulb cool completely before
removing it. Do not touch a hot
bulb with a damp cloth° If you
do, the bulb will break.
Glass Retainer.,..,x
Butb
Screw
ilass Cover
To remove:
o Remove the 3 slotted screws in
the lamp cover.
e Detach lamp cover ring, crystal
and gasket and remove bulb.
To replace:
o Put in a new 40-watt appliance
bulb. (Note: A 40-watt appliance
bulb is smaller than a standard
40-watt household bulb,.)
• Install lamp cover. Replace 3
screws and tighten, making sure
cover fits flush with oven wall.
o Reconnect electrical power to
the range°
(continuednextpage)_
23