Software Settings; Telephone Function Settings; Setting The Dialing Mode (Tone/Pulse) - Brother MFC 7550MC Setup Manual

3. SOFTWARE SETTINGS
A. TELEPHONE FUNCTION SE'IVI'INGS
There are some settings, such as the date and time, you should set on yum machine
before you begin using it. Once entered, these settings will remain in the machine
until you change them. You can begin customizing the settings by pressing Function
on the control panel. This activates the function mode and On-Screen Programming
prompts. You can complete a variety of settings in this mode.
(This chapter (TELEPHONE FUNCTION SETTINGS) is also inserted in the
Operations Manual. Please refer to the Operations Manual page 3-1-11 for more
information.)
Setting the Dialing Mode (Tone/Pulse)
Your machine supports both tone (multi-frequency) and pulse (rotary) dialing. It is
initially set to TONE, so you do not have to change the setting if you use that kind of
line. If you are using a pulse dial line, you can change the setting to PULSE by
following the steps below:
i|:l:l m_]I,_!'._'ILq! _:l:[eJ',¥
1.
Press Function.
You will see scrolling options on the
display. You can choose one.
(The MFC 4550 will skip to Step 4.)
2. Wait for two seconds.
(Only for MFC 6550MC/7550MC)
3, Press 1,
(Only for MFC 6550MC/7550MC)
4. Press 6.
oo:oo ]
L
NO
(Only for MFC ( m FAX *" .... :
6550MC/ [_-" .....
,t ! ;,: • ; t
7550MC
(Onlyfor MFC
6550MC/
7550MC)
5. Press 1.
After two seconds you will be prompted to
select pulse or tone.
6. Press -_ (left arrow) or D,_ (right arrow)
to find thb*' dialing mode that matches
your telephone line.
Exhmple: PULSE.
IUI III II I II I
3-1