Mixer In Audio Interface Mode; Volume, Reverb Send, Pan; Stereo Link; Balance - Zoom R8 Interface Manual

Mixer in audio interface mode

In audio interface mode you can make a mix for monitoring using the
mixer In addition, you can adjust the balance of the sound from the internal mixer and
from the computer

Volume, reverb send, pan

You can be adjust the reverb send, pan,
volume and stereo link settings in the same
way as in recorder mode.
Operation is the same as in recorder mode.
(Reference: Operation Manual P.42)
PAN/EQ menu
VOLUME
Adjust the volumes of INPUTS 1–2.
REV SEND
Adjust the reverb send levels of INPUTS 1–2.
PAN (BALANCE)
Adjust the pan for INPUTS 1–2.
26
0–127 (increments of 1)
Default value: 100
0~100 (increments of 1)
Default value: 0
Reverb only affects the
monitored signal (as in
recording mode).
L100~R100
(increments of 2)
Default value: Center
(as in recording mode)

Stereo link

Link INPUT 1 and 2 to handle them as stereo
pairs.
On/Off
Default setting: Off
By setting up a stereo link, volume, reverb send and pan
track parameters can be shared by
(Reference: Operation Manual P.29)

Balance

In audio interface mode, the balance of the
input monitoring signal and the signal from
DAW software (the computer) can be adjusted
with the BALANCE knob.
Left
Only the INPUT
1–2 signals
NOTE
The reverb send, pan, volume and stereo link
s e t t i n g s a r e a l l s ave d w h e n yo u e n d ( EXIT)
audio interface mode and can be used again the
next time .
internal
INPUT 1 and 2
.
Right
Only the DAW
stereo signal