Getting Started; Batteries; Change Settings; Remote Sensor (Thgr122Nx) - Oregon Scientific RMR612HGA User Manual

GETTING STARTED

BATTERIES

Insert batteries before first use, matching the polarity as
shown in the battery compartment. For best results,
install batteries in the remote sensor before the main
unit. Press RESET after each battery change.
NOTE
Do not use rechargeable batteries.
shows when batteries are low.
UNIT
Main
Remote

CHANGE SETTINGS

1. Press and hold MODE for 2 seconds to enter setting
mode.
2. Press UP or DOWN to change settings.
3. Press MODE to confirm.
RMR612HGA lab test R2
LOCATION
Temperature Area when
INDOOR temperature is
shown.
Temperature Area when
OUTDOOR temperature is
shown.
6
6

REMOTE SENSOR (THGR122NX)

This product is shipped with a THGR122NX Thermo/
Hygro Sensor that collects Temperature and Humidity
data. Data can be collected from up to 3 sensors.
Additional sensors sold separately.

SETUP SENSOR

Open the remote sensor battery compartment with a
small Phillips screwdriver.
1. Insert the batteries, matching the polarity as shown
in the battery compartment.
2. Set the channel. The switch is located in the
battery compartment.
SWITCH OPTION
Channel Channel 1 - 3. If you are using
more than one sensor, select a
different channel for each sensor.
3. Place the sensor near the main unit. Press RESET
on the sensor to initiate signal sending between the
sensor and the main unit. The reception icon on
the main unit will blink for approximately 3 minutes
while it is searching for the sensor. (Refer to the
Sensor Data Transmission section for more
information.)
4. Close the remote sensor battery compartment.
5. Secure the sensor in the desired location using the
wall mount or table stand.
1/17/04, 4:58 PM