GE PTS25LBMBRBB Owner's Manual And Installation Instructions page 17

Installation Instructions
[] CONNECT THE TUBING TO THE
REFRIGERATOR (CONT.)
lnsert the end of the tubing into the water vah'e
connection as far as possible. While holding the
tuhing, tighten the fitting.
For plastic tubing from a GE SmartCnnnect
TM
Refrigeralor Tubing "kit, insert the molded end of
the tubing into the shutoffvalve and tighten
cnmpression nut until it is hand tight, then tighten
one additional tuna with a wrench. Overtightening
may cause leaks.
Fasten flae tubing into the clamp provided tn hold
it in a vertical position. You may need to ply open
the clamp.
Tubing
Nut
Smaagonnect
TM
tubing
I_TURN THE WATER ON AT THE
SHUTOFF VALVE
Tighten any connections that leak.
Reattach tile access cover,
[] PLUG IN THE REFRIGERATOR
Arrange the coil of tuhing so that it does not vii)rate
against the back of the refrigerator or against the
wall. Push the refrigerator back _o the waU.
START THE ICEMAKER
Set flae icemaker
power switch to the I (On)position,
The icemaker will not begin to operate until it
reaches it.s operating temperature of 15°F
(-9 °C) or below. It will then begin operation
automatically if the icemaker power switch is in
tie I (on) position.
I
NOTE: In lower water pressure conditions, the
• a_ater valve may turn on up to 3 times to deliver
enough water to tile icelnaker.
17