Advertisement
.... %
j
C
--w
_TEf_
A
B
C
D
TABLE OF LOOSE PARTS
Basic saw assembly ..........................
Owners Manual .................................
Saw Table ................. :......................
Loose Parts Bag
Containing the following parts:
Key Switch .......................................
Wing Nut IJ4-20 .................................
Screw, Truss Hd I/4-20 x 5/8 ............
Wrench, Hex "L" 1/8 ........................
Bevei Indicator ..................................
Screw Pan Cross 1032 x 3/8 ...........
Washer !7/64 x 1 x 1/16 ....................
Bolt, Carriage 1/4-20 x 1 ....................
Knob ......: .........................................
Clip Hose .......................................
11
assembly
MOUNTING BAND SAW TO WORKBENCH
If band saw is to be used in a permanent location, it
should be fastened securely to a firm supporting sur-
face such as a workbench.
If mounting to a workbench,
holes should be drilled
through supporting
surface of the workbench
using
dimensions illustrated,
1. Each leg should
be bolted secureiy
using 5/t6"
diameter machine screws, tockwashers, and 5/16"
hex nuts (not included). Screw length should be
1-3/4" plus the thickness of the bench top.
2, Locate and mark the holes where band saw is to
be mounted.
3. Drill (4) 3/8" diameter holes through workbench.
4. Place band saw on workbench
aligning holes in
feet with holes driiled in workbench.
5. Insert all four 5/16" screws and tighten.
NOTE: All bolts should
be inserted
from the top.
Install the washers and nuts from the underside of the
bench.
"_
3/8" DtAMETEJ_R +
6-5/16"
(4) HOLES
'_'-------
16-13/16"
CLAMPING BANDSAW TO WORKBENCH
The Band Saw can be clamped directly to a work-
bench using two (2) or more 'C" clamps on base of
unit.
Base
Workbench
7
Advertisement
