Advertisement
maintenance
WARNING: For your own safety, turn switch
"OFF", remove switch key and remove P_ug
from power out_et before maintaining
or _ub_'icating your band saw.
TIRES
Pitch and sawdust
that accumulates
on the tires
should be removed with a stiff brush or scraped
off
with a piece of wood. Do not use a sharp knife or any
kind of solvent,
GENERAL
Keep your Band Saw clean.
Remove sawdust from the inside frequently,
Do not allow pitch to accumulate on the table, blade
guides,
or thrust
bearings.
Clean
them
with
Craftsman Gum and Pitch Remover,
Apply a thin coat of automobile-type wax to the table
top so the wood slides easily while cutting, Also apply
wax to the inside surfaces of the trunnion.
MOTOR!ELECTRQCAL
Frequently vacuum or blow out any sawdust from the
motor.
Wiring
O_agt'ar_
L
eiack
___Green
Ground
Screw
WARNBNG: ff the power cord is worn, cut,
or damaged
in any way, have it
replaced immediately.
WARNING: To avoid fire or e_ec_rocation,
reassemb0e eBectric parts with only approved
service parts. ReassembSe exactly as
originally
assembled.
LUBRICATION
Alt of the BALL BEARINGS are permanent{y iubricab
ed. They require no further lubrication.
sears recommends
the foBtowing accessories
Sears may recommend other accessories not listed in
manual.
See your nearest Sears Store or Catalog Department
for other accessories.
Do not use any accessory unless you have received
and read complete instructions for its use.
item
Cat, No.
Miter Gauge ...................................................
9-24214
Btades (56_7,'8'" length) ............................
See Catalog
t eg Set .........................................................
9-22244
Power Too_Handbook ....................................
9-29117
19
Advertisement
