Assembly And Adjustments; Assemble Stand; Assembly Miter Saw To Stand - Craftsman MULTI-MITER 137.242760 Operator's Manual

ASSEMBLY INSTRUCTIONS
IA WARNING I
To avoid injury, do not connect this miter saw to the power
source until it is completely assembled and adjusted, and
you have read and understood this Operators Manual.
ASSEMBLE STAND (Fig. A)
1. Unpack all parts and group by type and size. Refer to
the parts list on page 32 for correct quantities.
2. Attach one long upper support (4) to top of leg (1)
using one carriage bolt (2) and nut (5).
NOTE: Do not tighten bolts until stand is propedy
aligned (see step #8).
3. Attach other end of long upper support to the top of
another leg using one carriage bolt and one nut.
4. Attach one long bottom support (3) to the center of
each leg using carriage bolt and nut. This completes
the front frame section.
5. Assemble the rear frame section in exactly the same
manner.
6. Join the front and rear frame assemblies using two
short upper supports (11) and two short bottom
supports (10), carriage bolts and nuts.
7. Place all four rubber feet (7) onto each leg.
8. Place the stand on a level surface and adjust it so all
legs are contactingthe floor and are at similar angles
to the floor. Tighten all bolts.
NOTE: Stand should not rock after all bolts are
tightened.
ASSEMBLE MITER SAW TO STAND
1. Carefully place the miter saw on top of stand.
2. Line up the three mounting holes in the saw base to
the stand.
3. Fasten the saw to the stand using the three mounting
bolts (12), three washers (13) and three nuts (14).
NOTE: Place a washer on each bolt before
inserting it into the saw base and through the
support, then thread the nut onto the bolt (see
Fig. A)
4. Tighten all three nuts.
NOTE: DO NOT OVER TIGHTEN THE LOCK NUTS
HOLDING SAW TO THE STAND. THIS COULD
DAMAGE THE SAW BASE.
12
Fig. A
11
5
10
14
1
]0