Unpacking Your Folding Miter Saw; Assembly And Adjustments - Craftsman CMXEMAR120 Instruction Manual

English

UNPACKING YOUR FOLDING MITER SAW

B
D
F
8
A
C
E
G

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Assembly Instructions To Raise The Cutter
Head (Fig. B, C, D)

WARNING: To avoid injury, make sure all parts
are assembled and adjusted properly before
plugging the miter saw into a power outlet and
turning it ON.
1. Remove saw from the support base. Place saw with
blade and fence side facing up on a flat, stable surface.
2. Thread the miter handle
front of the table as shown in Fig. B.
3. Loosen the bevel lock knob
as shown in Fig. C.
4. Pull out the safety lock pin
lock knob.
5. Grasp the cutting head by the switch handle
raise the cutting head up to the vertical position just
pass the 0° bevel setting.
6. Tilt the cutting head back to 0° and then tighten the
bevel lock knob . The pin will automatically insert
12
into the slot, locking the head in position.
7. Loosen the miter handle
positive stop locking lever
handle, to turn the table to 0° as shown on the miter
scale. Retighten the miter handle
8. Slightly push down the cutting head using the switch
handle and pull out the hold-down latch
2
near the back on the left side of saw. This releases the
cutting head from the its locked position to swing
upward into operation position.
Fig. B
8
into the hole located at the
7
12 located behind the base
located next to the bevel
16
2 and
7 , grasp it and lift up the
8 located under the miter
7 .
located
13
7