Accessories And Attachments; Tools Needed For Assembly; Recommended Accessories - Craftsman MULTI-MITER 137.242760 Operator's Manual

RECOMMENDED ACCESSORIES
IA, WARNING]
• Use only accessories recommended for this miter saw.
Follow instructions that accompany accessories. Use
of improper accessories may cause hazards.
• The use of any cutting tool except 10 inch saw blades
which meet the requirements under recommended
accessories is prohibited. Do not use accessobes such
as shaper cutters or dado sets. Ferrous metal cutting
and the use of abrasive wheels is prohibited.
• Do not attempt to modify this tool or create
accessories not recommended for use with this tool.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious injury.
ACCESSORIES
Visit your Sears Hardware Department or see the Sears
Power and Hand Tool Catalog to purchase recommendec
accessories for this power tool.
[A WARNING I
To avoid the risk of personal injury, do not modify this
power tool or use accessories not recommended by Sear
I,A WARNING]
Read warnings and conditionson your CARBIDE TIPPEr
SAW BLADE. Do not operate the saw without the proper
saw blade guard in place. Carbide is a very hard but brittle
material. Care should be taken while mounting, using, and
storing carbide tipped blades to prevent accidental
damage. Slight shocks, such as striking the tip while
handling, can seriously damage the blade. Foreign objects
in the workpiece, such as wire or nails, can also cause tips
to crack or break off. Before using, always visually
examine the blade and tips for bent teeth, cracks,
breakage, missing or loose tips, or other damage. Do not
use if damage is suspected. Failure to heed safety
instructionsand warnings can result in serious bodily
injury.
Blade wrench (supplied) Adjustable wrenCh
Phillips screwdriver
_ver
===J
Combination square
COMBINATION SQUARE MUST BE TRUE
Draw a light line
on a board along
this edge. ,--
s_J
Straight edge or
a 3/4" board, this
edge must be
perfectly straight
Should not gap or overlap
when square is flipped over
in dotted position
I 6