Table of Contents
Advertisement
motor specifications
and electricam requirements
This machine isequipped with, a 1725 RPM motor. It is
wired for operation on 120 volts, 60 Hz, alternating
current.
For replacement motor, refer to parts list in this manual.
t WARNING:
Do not permit fingers
to touch the I
terminals of plugs when installing or removing
I
the plug to or from the outlet.
Plug power cord into a 120V properly grounded type
outlet.
CONNECTING
TO POWER SUPPLY
OUTLET
If powercord is worn orcut, ordamaged in anyway, have
it replaced immediately.
WARNING:
If not properly grounded, this power
too! can cause an electrical shock, particularly
when used in damp locations
close to plumbing.
If an electrlca! shock occurs there is the potential
of a secondary hazard, Such as your hands con-
tacting t he saw blade.
If you are not sure that your outlet, as pictu red below, is
properly grounded, have it checked by a qualified elec-
trician.
Your unit is for use on 120 volts, and has a plug that looks
like the iflustration below.
This power toolis equipped with a 3-conductor cord and
grounding
type plug which has a grounding prong,
approved by Underwriters' Laboratories.
The ground
conductor has a green jacket and is attached to the tool
housing at one end and to the ground prong in the
attachment plug at the other end.
This plug requires a mating 3-conductor grounded type
outlet as shown.
I
O
3-PRONG
PLUG
GROUNDING
PRONG
PROPERLY
GROUNDED
OUTLET
If the outlet you are planning to use for the power tool is
of the 2 prong type, DO NOT REMOVE OR ALTER THE
GROUNDING
PRONG IN ANY MANNER.
Use an
adapter
as shown below
and always
connect
the
grounding tug to known ground.
It is recommended that you have a qualified electrician
replace the TWO prong outlet with a properly grounded
THREE prong outlet.
GROUNDING LUG
SCREW
/
{*:-=-_
/
l_, t_" 'i
MAKE SURE THIS tS
............
CONNECTED
TOA
/
_'"
RECEPTACLE
ADAPTER
An adapter as illustrated is available
for connecting
plugs to 2-prong receptacles.
WARNING:
The green grounding lug extending
from the adapter must be connected to a perma-
nent ground such as to a properly grounded
outlet box,
Not all outlet boxes are properly
grounded.
If you are not sure that your outlet box is properly
grounded, have it checked by a qualified electrician,
NOTE:
The adapter illustrated is for use only if you
already have a properly grounded 2-prong receptacle.
The use of any extension cord will cause some loss of
power.
Use only a single 3 wire extension cord with a 3-prong
grounding type pfug and 3-prong receptacle which ac-
cepts the tools plug for this 2 amp tool.
Length of the
Conductor
dpto 100 feet
Wire Sizes Required
(American Wire Gauge Number)
120V Lines
No. 16
=
i1,11 I
lllil
Hide quick links:
Advertisement
Table of Contents
