Making Interior Cuts; Mounting Auxiliary Surface For The Work Table - Craftsman 113.23611t Owner's Manual

KEEPCHILDREN AWAY. Keepall visitors a safe
distance f romthe saw.Make surebystanders areclear
ofthesawandworkpiece.
DON'T FORCE TOOL.Itwilldothejobbetter a ndsafer
at itsdesigned rate. Feed theworkpiece i ntothesaw
blade
only fast enough to let it cut without bogging down
or binding.
Before freeing any jammed material:
• Turn switch "OFF".
, Remove switch key.
° Unptugthe saw.
- Wait for all moving parts to stop.
When backing up the workplece, the blade may bind
In the kerr (cut). This Is usually caused by sawdust
clogging up the kerr. if this happens:
, Turn switch "OFF'.
, Remove switch key.
° Unplug saw.
• Wait for all moving parts to stop.
o With a fiat blade screwdriver, turn the motor by ha_,_d
while backirg up tile workpiece_
Before removing loose pieces from the tab_,e,turn
saw off and wait for ai| moving parts to sfop.
BEFORE LEAVING THE SAW:
Wait for all moving parts to stop.
MAKE WORKSHOP CH!LDoPROOF. Unplug _he s_w
LOCkthe shop or on/off knob. Store the key' away from
children and others not qualified to use 1he IooL
MAKING INTERIOR SCROLL CUTS
1. One of the features of this saw isthat it can be used
to make scroll cuts on the interior of a board without
breaking or cutting into the outline or perimeter of the
board.
WARNING: TO avoid Injury from accidental
starting, always turn switch "OFF" and remove
switch key before removing or replacing the
blade.
2. To make interior cuts in a board, remove the scroll
saw blade as explained in the Assembly section.
3. Drill a 1/4" hole in the board you will use to make
interior cuts.
4. Place the board on the saw table with the hole in the
board over the access hole in the table.
5. Install blade through hole in board and adjust blade
tension.
6. When finished making the interior scroll cuts, simply
remove the blade from the blade holders, as de-
scribed in the Assembly section, and remove the
board from the table.