Frigidaire LEGFM389FEA Use & Care Manual page 32

Care &Cleaning
Door Hinge
locations
with oven door
fully open
Fig. 1
Fig. 2
Removing and Replacing the Lift-Off Oven Door
The door is heavy, For safe, temporary storage, Uay the door fiat
with the inside of the door facing down,
To Remove Oven Door:
1, Open oven door compbteUy (horizontaU with floor - See Fig, 1 ),
2, Pull the door hinge bcks on both bft and right door hinges down from the
oven frame compbteUy towards the oven door (See Fig, 2), A tooUsuch as a
small fiat:Made screwdriver may be required,
3, FirmUygrasp both sides of oven door abng the door sides (Do not use the
oven door handb : See Fig, 3),
4, Cbse the door to the broil stop position (the oven door wHU stop into this
position just before fully closing),
5, With the oven door in the broil stop position, lift the oven door hinge arms over
the roller pins located on each side of the oven frame (See Fig, 4),
To Replace Oven Door:
1, Firmly grasp both sides of oven door along the door sides (Do not use the
oven door handle - See Fig, 3),
2, Holding the oven door at the same angle as the removal position, seat the
hook of the hinge arm over the roller pins located on each side of the oven
door frame (See Fig, 4), The hook of the hinge arms must be fully seated
Hinge
Hook
Oven
Door-
Fig. 3
Fig. 4
3, Fully open the oven door (horizontal with floor ° See Fig, 1 ),
4, Push the door hinge locks up towards and into the oven frame on both left
and right oven door hinges (See Fig, 2) to the locked position,
5, CIosetheoven door,
Specia_
Door Care mnstructions
Most oven doors contain gJass that can break. Read the following
recommendations:
1, Do not close the oven doer until all the oven racks are fully in place,
2, Do not hit the glass with pots, pans, or any other object,
3, Scratching, hitting, jarring or stressing the glass may weaken its structure
causing an increased risk of breakage at a later time,
Changing the Oven Light
The oven light automatically turns ON when the door is opened, The oven light
may also be manually operated by pressing the @
pad, The oven light bulb is
located at the rear of the oven and is covered with a glass shield held by a wire
holder (See Fig, 5), The glass shield must be in place whenever the oven is in
use,
Oven
Light
Wire
Holder
To reptace the oven Hght bulb:
1, Turn electrical power off at the main source or unplug the range,
2, Press wire holder to one side to release the glass shield,
8, Replace bulb with a new 40 watt appliance bulb,
4, Replace glass shield over bulb and snap wire holder into place,
5, Turn power back on again at the main source (or plug the range back in),
6, The clock wiii then need to be reset, To reset, see Setting the CJock and
Minute Timer in this Use & Care Manual,
Fig. 5
Be sure the range is unplugged and all parts are COOL before
replacing oven light, Wear a bather-faced glove for protection against possible
broken glass,
32