Frigidaire LEGFM389FEA Use & Care Manual page 31

t i/} {) i ¸ { : {
Care & Cleaning
C_eaning the Contoured Cooktop Well Areas, Burner Cap, Burner Head and Burner Drip Pans
(some modeb)
The contoured well areas, burner cap, burner head and burner drip pans (some models) should be routinely cleaned,
Keeping the burner ports clean wiii prevent improper ignition and an uneven flame, Refer to the following instructions:
THE COOKTOP IS NOT REMOVABLE, Do not attempt to remove or lift the cooktop,
Use caution when replacing the burner cap so the electrode is not damaged, This may cause a delayed
ignition or prevent the burner from igniting,
To Ctean the Recessed & Contoured Areas of the Cooktop - if a spill Surface
Bumer
occurs on or in the recessed or contoured areas, blot up spill with an Grate
absorbent cloth. Rinse with a clean, damp cloth and wipe dry.
To Remove & Replace the Surface Burner Caps & Surface Burner
Heads - Remove in the following order: (1st) surface burner grate, (2nd)
surface burner cap, (3rd) surface burner head and (4th) surface burner drip pan
(if equipped).
Reverse the procedure above to replace the surface burner cap, surface burner
head and surface burner drip pans (if equipped), Do not remove any parts
from the cooktop untit they have compteteJy cooJed and are safe to
handte. Do not operate the surface burners without the surface burner
cap and surface burner head properly in place.
JOdfice i
To Clean the Surface Burner Cap, Surface Burner Head & Surface Hotde
Burner Drip Pan (if equipped} - Use a soap=filled scouring pad or a mild
abrasive cleanser to clean the surface burner caps, surface burner heads and
surface burner drip pans (if equipped). The ports (or slots) around the burner
head must be routinely cleaned, if residue still remains in these ports, use
a
..._ctrod
small-gauge wire or needle to clean the slots or hobs. For proper flow of gas
and ignition of the burner--DO NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS OR ANY OTHER MATERIALTO ENTER THE GAS ORIFICE
HOLDER OPENING. ALWAYS keep the surface burner cap and surface
burner head in place whenever a surface burner is in use.
Surface
Burner
Cap
Surface
Burner
Head
Removable
Burner
Drip Pan
(on some models)
31