Craftsman evolv 320.31024 Operator's Manual page 25

TO ADJUST 0° BEVEL STOP (Fig. 18)
Remove the battery pack
from the saw. Fig. 18
1.
2.
3.
Loosen the bevel
adjustment knob.
Place the saw in an upside
down position on
a workbench.
4. Using a Philips-screwdriver,
turn the 0° bevel stop
adjusting screw until the base
is square with the saw blade.
_, WARNING: Attempting to
make cuts without the bevel
adjustment knob securely
tightened can result in serious injury.
0° bevel stop
/_usting screw
MAKING A POCKET CUT (Fig. 19)
_, WARNING: Always adjust
the bevel setting to zero before
making a pocket cut. Attempting
a pocket cut at any other setting
can result in a loss of control
of the saw, which can result in
serious injury.
1. Adjust the bevel setting to
0 ° and tighten the bevel
locking knob.
2. Set the blade to the correct
blade-depth setting and
tighten the depth-locking lever.
Swing the lower blade guard
up using the blade guard lever.
Fig. 19
lower blade
guard level
lower blade
3.
4. Hold the lower blade guard in place with the blade guard lever.
5. Rest the front of the base flat against the workpiece, with the rear of the
handle raised so that the blade does not touch the workpiece.
6. Press the lock-off button and depress the trigger switch to start the saw.
7. Allow the blade to reach full speed, then guide the saw into the workpiece
and make the cut.
8. Release the trigger switch and allow the blade to come to a complete stop.
9. Lift the saw from the workpiece.
31024Manual Revised 11-0629 Page25