Table of Contents
Advertisement
HOW TO CHARGE
THE BATTERY PACK (Fig. 2)
Detach the battery pack from the
circular saw.
Insert the power unit jack into the
charging socket, making sure that
it is properly connected.
Power unit can be used with
normal house voltage of 120
volts, 60 Hz, AC only.
Connect
the power unit plug to
an electrical
outlet. The indicator
light on the battery pack shines
red when the power unit is
plugged
into a power source.
Charge the battery for at least 7
hours before the first use.
Fig. 2
Charging
socket
Power unit
For best results, do not recharge
the battery for less than 5 hours or more than 7
hours after each use.
Do not place the power unit in an area of extreme heat or cold. It works best at
normal room temperature.
The base of the battery
or power
unit may become
warm
during
charging.
This is normal.
TO ATTACH BATTERY PACK (Fig. 3)
1. Make sure that the circular
saw is turned off.
Fig. 3
2.
Align the raised platform on
the battery pack with the
grooves on the bottom of the
saw main handle, and then
slide the pack into the handle.
See Fig. 3.
NOTICE: When inserting the
battery pack into the tool, make
sure that the raised platform
on
the pack aligns with the grooves
on the bottom
of the tool main
Attach
handle, and that the latches snap
properly into place. Improper
assembly
of the battery pack can cause damage to internal components.
Battery pack
release button
31024Manual
Revised 11-0629
Page 15
Advertisement
Table of Contents
