Table of Contents
Advertisement
_,
WARNING:
Attempting
a bevel cut without
having the bevel-locking
knob
securely
locked in place can result in serious injury.
4.
Hold the saw firmly with both hands, as shown.
5.
Rest the front edge of the base on the workpiece
without
touching
the blade
to the workpiece.
6.
Start the saw and allow the blade to reach full speed.
7.
Guide the saw into the workpiece,
and make the cut.
8.
Release the trigger switch and allow the blade to come to a complete
stop.
9.
Lift the saw from the workpiece.
_,
WARNING:
If the blade comes
in contact
with the workpiece
before it
reaches full speed, it could cause the saw to kick back towards
you, possibly
resulting
in serious injury.
0 ° BEVEL STOP
The saw has a 0 ° bevel stop that has been adjusted
before shipment
to assure
the blade is vertical to the base at 0 ° bevel cutting.
TO CHECK
0° BEVEL STOP (Fig. 17)
1. Remove the battery
pack from the saw.
WARNING:
Always
remove
the battery
pack from the
saw when assembling
parts,
changing
blades
or making
adjustments.
Failure to obey
this warning
could
cause
serious
personal
injury.
2.
Using
a carpenter's
square,
check
that the saw blade
is
square
(at a 90 ° angle) to
Base
the base of the saw.
Fig. 17
Carpenter's
square
Blade
31024Manual
Revised 11-0629
Page24
Advertisement
Table of Contents
