Table of Contents
Advertisement
TO ADJUST BLADE DEPTH
(Fig. 10)
1.
Remove the battery pack
from the saw.
2.
Loosen the depth-of-cut
quick
adjustment clamp lever.
3.
Hold the base flat against
the workpiece
and raise
or lower the saw until the
indicator
aligns with the
desired depth on the scale.
4.
Tighten the depth-of-cut
quick adjustment
clamp
lever securely.
Fig. 10
Depth scale
Depth-of-cut
quick
adjustment
clamp lever
USING EDGE GUIDE (sold
separately)
(Fig. 11)
Always
use a guide when making
long or wide rip cuts with your
saw. You can use either a
straight
edge or use an edge
guide (sold separately).
NOTICE: The edge guide can be
used on the left or right side of
the blade (Fig. 11).
_lk WARNING:
Always remove
the battery pack from the
saw when assembling
parts,
changing
blades and making
Fig. 11
Edge
i ,
guide locking knob
U
I
Edge guide
adjustments.
Failure to obey this warning could cause serious personal injury.
1.
Remove the battery pack from the saw.
2.
Position the edge guide (sold separately)
so that the arm with the ruler side
is facing up. Slide the arm of the edge guide through
the mounting
slots at
the front of the saw base.
3.
Adjust the edge guide to the desired width of cut.
4.
Tighten the edge guide locking knob.
5.
When using an edge guide, position
the face of the edge guide firmly
against the edge of the workpiece.
This will help make a true cut without
binding the blade. The edge of the workpiece
must be straight
for the cut to
be straight.
Use caution to prevent the blade from binding in the cut.
_,
WARNING:
Do not bind the blade in the cut. It could cause the saw to
"kickback"
towards
you, which could result in serious injury.
31024Manual
Revised 11-0629
Page20
Advertisement
Table of Contents
