Craftsman 113.235500 Owner's Manual page 9

2. Use a small square to set the table at 90 ° to the
blade. If there is too much space between the square
and the blade, the table must be adjusted.
3. When the space between the square and the
blade is minimal, tighten the bevel lock knob_ The
table should now be approximately 90 ° to the blade.
4. Loosen the screw holding the bevel scale
pointer and adjust to 0°. Tighten screw.
Remember, the bevel scale is a convenient guide
but should not be relied upon for precision.
Make practice cuts in scrap wood to determine if
your angle settings are correct Adjust the table as
required.
/
BEVEL POINTER
9