Receiver And Remote Control Programming - Craftsman 139.53978SRT Owner's Manual

Receiver and Remote Control Programming
SE( URri '.F
To complywdhFCC rules,adjustmento¢modifications o f this receiver andfor
transmitterare prohtbRed, except for changingthe code settingor replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Your garage door opener receiver and remote
control have been pre-set at the factory. The door
will open when you press the LARGE remote
control push button. The code between the remote
control and the receiver changes with each use,
randomly accessing over 100 billion new codes.
The 3-function remote control can also activate
additional SECURITY,I, garage door openers and/or
light controls.
Your SECURITY+ opener will operate with:
• several SECURITY,I, remote controls (with blue
push buttons) utilizing up to 8 functions.
• one SECURITY+ Keyless Entry System
(Model 139.53684).
Follow the instructions below to program your
opener to match any additional remotes you may
_urchase. See Accessories on page 38.
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause setfous
injury or death. Do not allow children to operate
the door push button(s) or remote control(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
To Add A Remote Control
If you have a Premium Control Console:
1. With the doorc/osed, press and hold a remote
control push button. See Figure 1.
2. Press and hold the Light button on the door
control.
3. Press and hold the door control push button.
4. After the opener light flashes, release all buttons.
Test by pressing the remote push button.
If you do not have a Premium Control Console:
1. Press and holdthe selected remote control push
button. See Figure 1.
2.Then press and release the SRT (learn) button on
the back panel of the opener, Figure 2. The
indicator light on the panel will begin to blink and
the opener light will flash once.
3. Release the remote push button.
Test by pressing the remote push button.
To Erase All Remote Control Codes
Press and hold the SRT button on the opener panel
until the indicator light turns off (about 6 seconds).
All remote control codes are now erased. Then
follow the steps above to re-program each remote
control.
Figure I
Select a remote control push
button to operate opener
SECURITY'I'
3-Function
Remote Control
Figure 2
SECURITY,I,
Garage Door Opener
SRT (leam) Indicator BACK
Button Ught PANEL
Code programming instructions are
also located on the opener panel,
33