Receiver And Remote Control Programming - Craftsman 139.18887 Owner's Manual

Receiver and Remote Control Programming

To comply with FCC/IC rules, adjustment or modifications of this receiver
and/or transmitter are prohibited, except for changing the code setting or
replacing the battery. THERE ARE NO OTHER USER SERVICEABLE
PARTS.
SECURITY
Your garage door opener receiver and remote
control have been pre-set at the factory. The door
will open when you press the LARGE remote
control push button. The code between the remote
control and the receiver changes with each use,
randomly accessing over 100 billion new codes.
The 3-function remote control can also activate
additional SECURITY garage door openers and/or
light controls.
Your SECURITY opener will operate with:
• several SECURITY remote controls (with blue
push buttons) utilizing up to 8 functions.
• one SECURITY Keyless Entry System (Model
18795).
Follow the instructions below to program your
opener to match any additional remotes you may
purchase. See Accessories on page 38.
To Add A Remote Control
If you have a Premium Control Console:
1. With the door closed, press and hold a remote
control push button. See Figure 1.
2. Press and hold the Light button on the door
control.
3. Press and hold the door control push button.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button.
If you do not have a Premium Control Console:
1. Press and hold the selected remote control push
button. See Figure 1.
2. Then press and release the "SRT" (learn) button
on the right side panel of the opener, Figure 2.
The indicator light on the panel will begin to blink
and the opener lights will flash once.
3. Release the remote push button.
Test by pressing the remote push button.
To Erase All Remote Control Codes
Press and hold the "SRT" button on the opener
panel until the indicator light turns off (about
6 seconds). All remote control codes are now
erased. Then follow the steps above to re-program
each remote control.
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause serious
injury or death. Do not allow children to operate
the door push button(s) or remote control(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
Select a remote control push
Figure 1
button to operate opener
SECURITY
3-Function
Remote Control
Figure 2
1 2 3
9 1 9
7 3 7
5 5
KG
KG
RIGHT SIDE PANEL
To Control the Opener Lights (Premium Consoles)
With SECURITY remote controls, a push button can
be programmed to operate the opener lights without
opening the door.
1. With the door closed, press and hold the remote
button that you want to control the light.
2. Press and hold the Light button on the door control.
3. Press and hold the Lock button on the door control.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button. The opener
light should turn on or off but the door should not move.
33
WARNING
SECURITY
Garage Door Opener
1 2
1 9 1 9
3
7 3 7
5
KG
"SRT" (learn) Indicator
Light
Button
Code programming instructions are
also located on the opener panel.
3
1
3
5
KG