Oki C9200 Service Manual page 111

2-4 Paper Eject Jam
• Does the paper jam occur immediately after the printer is powered on?
• Yes Is the paper jammed at the ejection sensor?
Yes Remove the jammed paper.
• No Does the lever of the ejection sensor operate normally?
No Replace the ejection sensor lever.
• Yes Does the ejection sensor work properly?
(Operate the sensor lever and confirm that the sensor works properly or verify the signal on
the PARTTEMP connector Pin 8 on the engine board (K73 PWB).)
Pin 8: Ejection sensor
No Check the signal cable connection, or replace the ejection sensor.
• Yes Replace the engine board.
• No Dose the heat motor rotate properly?
• No Is the resistance of the heat motor at the rated value (approx. 7.9 )?
No Replace the heat motor.
• Yes Is +32V supplied to the POWER connector Pins 7~10 on the engine board?
No Replace the low-voltage power supply unit.
• Yes Check the connection of the cables, or replace the engine board.
• Yes Does the paper separator operate normally?
• No Does the paper separator solenoid work normally?
No Check the cable connection, or replace the solenoid or the engine board.
• Yes Replace the paper separator assy.
• Yes Replace the eject guide assy.
41388601TH Rev.2
111 /