1. Open the Switch Administration window as described in
2. Select the SNMP tab.
3. Select a trap level for a recipient from the corresponding Trap Level menu in the SNMPv1 and
4. Click Apply.
Changing the systemGroup configuration parameters
To change the systemGroup configuration parameters, perform the following steps.
1. Open the Switch Administration window as described in
2. Select the SNMP tab.
3. Enter a contact name, description, and location in the SNMP Information section.
4. Optional: Select the Enable Authentication Trap check box to allow authentication traps to be
5. Click Apply.
Setting SNMPv1 configuration parameters
To set SNMPv1 configuration parameters, perform the following steps.
1. Open the Switch Administration window as described in
2. Select the SNMP tab.
3. Double-click a community string in the SNMPv1 section and enter a new community string.
4. Double-click a recipient IP address in the SNMPv1 section and enter a new IP address.
5. Click Apply.
Setting SNMPv3 configuration parameters
NOTE
The port number is not included.
To set SNMPv3 configuration parameters, perform the following steps.
1. Open the Switch Administration window as described in
2. Select the SNMP tab.
Web Tools Administrator's Guide
53-1002756-01
window"
on page 31.
SNMPv3 sections.
The level you select identifies the minimum event level that prompts a trap.
NOTE
Adding or editing the user name can be done only through the CLI and by selecting a user
name from the User Name menu in the SNMPv3 section.
window"
on page 31.
sent to the reception IP address.
window"
on page 31.
window"
on page 31.
SNMP configuration
"Opening the Switch Administration
"Opening the Switch Administration
"Opening the Switch Administration
"Opening the Switch Administration
15
181