Fibre Channel (Configuration); To Edit The Fc Configuration; Fibre Channel (Status) - HP StorageWorks D2D100 - Backup System User Manual

6. Configure zones on the FC Fabric/Switch.
7.
The library device(s) should now be visible to the host. It may be necessary to perform a system
re-scan.
Fibre Channel (Configuration)
There is a page on the Web Management Interface that allows you to view and edit Fibre Channel SAN
settings, if necessary. It shows FC settings for each port on the FC card.
To edit the FC configuration
Click Edit to make the fields editable for each port. Make the required changes and click Update.
• Speed: The default is Auto, which is the recommended option. For users who wish to fix the
speed, other available values are 1G (not recommended), 2G and 4G.
• Topology: The default is Auto, which is the recommended option. Loop, where the HP D2D
Backup System simulates a large number of FC devices, and N_Port, when a single host creates
many devices on the link, are also supported. N_Port requires the switch port to support NPIV
(N_Port ID Virtualisation).

Fibre Channel (Status)

This page shows the details for all the FC devices that are configured on the HP D2D Backup System.
Select a library in the Devices list to view the connection details for the library's media changer and
drive(s).
This page is mainly for information and is useful in troubleshooting. It cannot be edited.
D2D Backup SystemHP D2D4004 and HP D2D4009
61