and configures a library. If you are configuring the HP D2D as an FC device, this step
is not relevant and is omitted. This means that no base library device is created for
the host; you must do this after installation from the Web Management Interface, see
"To create a new
3.
Run the Installation wizard on any other hosts that are to be backed up—sixteen is the maximum. On
running the wizard on subsequent hosts, you only need to select the HP D2D Backup System; its
network settings have already been assigned.
The HP D2D Backup System does not appear as a device under My Computer and it is not mapped
to a drive letter (although it can be seen as a tape drive (1) and medium changer (2) from Device
Manager). Use a backup application on the host machine to back up and restore data.
Recommended web browser settings
The web browser used to communicate with the D2D Backup System must have Active Scripting or
JavaScript enabled. If it does not, some of the browser buttons may not be displayed.
device" on page 72.
D2D Backup SystemHP D2D4004 and HP D2D4009
35