Messages And Signals - Sharp FO-90 Operation Manual

all-fo90A.book Page 117 Monday, December 20, 1999 1:27 PM

Messages and Signals

Display messages
CHECK PAPER
COVER OPEN
DOCUMENT JAMMED
FUNCTION MODE
HOLD
LINE BUSY
LINE ERROR
MEMORY IS FULL
The thermal paper is jammed or isn't loaded properly.
Remove and reload the paper. (See the following
section, Clearing Paper Jams.)
The operation panel is open. Close it.
The original document is jammed. See the following
section, Clearing Paper Jams.
The FUNCTION key has been pressed.
The HOLD/SEARCH key has been pressed to put the
other party on hold during a phone conversation.
Press the HOLD/SEARCH key again to take the
other party off hold.
This appears if you attempt to send a fax by
automatic dialing and the line is busy or the receiving
fax machine doesn't answer. Press the STOP key to
clear the message.
Transmission or reception was not successful. Press
the STOP key to clear the message and then try
again. If the error persists, see Line Error in Problems
and Solutions in this chapter.
The memory is full. This may occur during fax
reception if too much data is received before the
pages can be printed out. If faxes have been received
to memory because printing is not possible (an
additional message will indicate the problem), resolve
the problem so that printing can continue (see
Substitue Reception to Memory in Chapter 4). If you
are attempting to transmit from memory, see Sending
Documents from Memory in Chapter 7.
Messages and Signals
117