System Connections - Sharp CD-XP500A Operation Manual

System connections

CD-XP500A
ENGLISH
AM loop aerial
Right speaker
! Removing the transport screw
Before turning the power on, be sure to remove the transport screw
on the back of the unit using a flat head screwdriver or a coin.
Note:
This screw is required when transporting the unit again. Please keep it (see page
27).
E-7
FM aerial
Transport screw
Left speaker
Wall socket
(See page 8.)
! Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM 75
OHMS terminal and position the FM aerial wire
in the direction where the strongest signal can
be received.
Supplied AM loop aerial:
Connect the AM loop aerial to the AM LOOP
socket. Position the AM loop aerial for opti-
mum reception. Place the AM loop aerial on a
shelf, etc., or attach it to a stand or a wall with
screws (not supplied).
Note:
Placing the aerial on the stereo system or near the AC power lead may cause noise
pickup. Place the aerial away from the stereo system for better reception.
Installing the AM loop aerial:
< Assembling >
External FM aerial:
Use an external FM aerial if you require better reception. Consult your dealer.
75 ohm
coaxial
cable
Note:
When an external FM aerial is used, disconnect the supplied FM aerial wire.
02/3/11 CD-XP500A(A)1.fm
< Attaching to the wall >
Wall Screws (not supplied)
External
FM aerial