Recording From A Cd (Cds) - Sharp CD-XP500A Operation Manual

Recording to a cassette tape
CD-XP500A
ENGLISH
Before recording:
! When recording important selections, make a preliminary test to ensure that the
desired material is properly recorded.
! SHARP is not liable for damage or loss of your recording arising from malfunction
of this unit.
! The volume and sound controls can be adjusted with no effect on the recorded
signal (Variable Sound Monitor).
! For recording, use only normal tapes. Do not use metal or CrO tapes.
Note:
Whilst recording, OPEN/CLOSE button is deactivated. It is recommended to per-
form CD recording after closing the disc tray.
E-21
Programmed play (See page 14.)
Recording can be operated in the TAPE 2 compartment. The TAPE 1 is for playback only.

" Recording from a CD (CDs)

You can record 3 CDs continuously.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a cassette into the TAPE 2 cassette compartment with side A
facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the CD button and load the desired disc.
4
Press the button to choose one
side or both sides.
... To record on both sides.
... To record on only one side.
5
Press one of the 1 - 3 buttons on the remote control to select
the disc to be recorded first.
6
Press the REC PAUSE ( ) button.
Recording will be paused.
7
Press the ( ) button to record on side A, or the
side B.
! To record on both sides, begin on side A. (If recording is started from side B,
the tape will not switch over to side A.)
! Recording is started from the selected CD. When the playback of the last disc
is finished or the end of the tape is reached, the CD and the cassette will stop
automatically.
! CD playback will start approximately 5 seconds after the tape starts.
To perform programmed recording:
1 Programme discs and tracks. (See page 14.)
2 Press the REC PAUSE ( ) button.
3 Press the ( ) button to record on side A, or the
To stop recording:
Press the button.
The CD and tape will stop.
Auto restart function:
If the recording side is switched from side A to B during recording, the system will
record the interrupted track on side B from its beginning. The recording will be made
without cutting the beginning of the track on side B.
02/3/11 CD-XP500A(A)3.fm
button for
button for side B.