Listening To A Cd (Cds) - Sharp CD-XP500A Operation Manual

Listening to a CD (CDs)

This system can also play audio CD-R and CD-RW discs, but cannot record.
Some audio CD-R and CD-RW discs may not be playable due to the state of disc or
the device that was used for recording.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD button.
3
Press the OPEN/CLOSE button to open the disc tray.
4
Place the CD(s) on the disc tray, label side up.
When loading a third disc, press the DISC SKIP button to turn the
disc tray, then place the CD in the open position.
! CDs can be placed on any open position on the disc tray.
! Be sure to place 8 cm (3") CD(s) in the middle of the disc positions.
5
Press the
Total number of tracks on the CD
whose number is flashing
6
To select the CD you want to listen to first, press one of
buttons on the remote control.
7
Press the
! Playback will begin from track 1 on the disc you have selected to play. After
that disc finishes playing, the next disc will automatically start playback.
! When the last track on the third disc has finished playing, the CD player will
stop automatically.
! When there is no CD in one of the disc 1 - 3 positions, that position will be
skipped and the next CD will be played.
To interrupt playback:
Press the button on the remote control.
To resume playback from the same point, press the
To stop playback:
Press the button.
To remove the CDs:
12 cm (5")
8 cm (3") Whilst in the stop mode, press the
The disc tray will open. Remove the two discs. Then, press the DISC SKIP button to
rotate the disc tray and remove the remaining disc.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
OPEN/CLOSE button to close the disc tray.
Total playing time of the CD whose
number is flashing
( ) button to start playback.
button.
OPEN/CLOSE button.
General control (See page 10.)
02/3/11 CD-XP500A(A)2.fm
CD-XP500A
ENGLISH
1 - 3
E-12