Creating Margins When Copying (Margin Shift) - Sharp AR-M161 Operation Manual

CREATING MARGINS WHEN COPYING
The margin shift function shifts the image to create a margin at the edge of the paper. By default the function creates
a 10 mm (1/2") margin at the left edge of the paper.
• You can select whether to create a margin at the top edge or at the left edge of the paper.
• Five selections are available for the margin width: 0 mm, 5 mm, 10 mm, 15 mm, 20 mm (0", 1/4", 1/2", 3/4", 1").
(The default setting is 10 mm (1/2").)
• When making two-sided copies, a margin is created at the selected edge on the front side of the paper, and a
margin is created on the back side of the paper.
• Margin shift cannot be used in combination with 2 in 1 / 4 in 1 copy (page 66).
• Margin shift cannot be used in combination with card shot (page 71).
• When margin shift is selected, rotating copying will not operate even if the condition for rotate copying is met.
• The default margin shift setting can be changed in the key operator programs. (Page 86)
1
Place the original in the document
feeder tray or on the document glass.
• When a left-edge margin is
When a left-edge margin is selected and you are
copying from the document glass, set the original
face down so that the margin edge is to the right.
• When a top-edge margin is selected, place the
original with the margin edge toward the rear of the
document feeder tray or the document glass.
2
Press the [SPECIAL FUNCTION] key.
2-SIDED
COPY
SPECIAL FUNCTION
DUPLEX SCAN
ACC.
The function screen appears with "SPECIAL MODES"
selected.
3
Press the [OK] key.
BACK OK
GHI
The special modes screen will appear with "MARGIN
SHIFT" selected.
68
Margin (top)
A A
Original Copy
selected and you are copying
from the document feeder
tray, place the original face up
so that the margin edge is to
the left.
SPECIAL FUNCTION
SPECIAL MODES
ORIG. SIZE ENTER
PAPER SIZE SET
DISPLAY CONTRAST
SPECIAL MODES
MARGIN SHIFT
ERASE
DUAL PAGE COPY
[OK]:ADJUST
Margin (left edge)
A A
Original Copy
4
Press the [OK] key.
OK
The settings for margin
shift will appear.
5
Select the margin location with the
[ ] or [ ] key and select the width
with the [ ] or [ ] key.
• Select "DOWN" or "RIGHT"
GH
• If you select 0 mm (0"), the
PQR
2-SIDED
COPY
SPECIAL FUNCTION
6
Press the [OK] key.
You will return to the base
OK
screen.
7
Select other copy settings as needed
and press the [START] key (
WXYZ
To turn off the margin shift
function, select the margin shift
@.- _
feature again and select "OFF".
READ-END
(Margin shift)
MARGIN SHIFT
OFF
DOWN
RIGHT
10 mm (0~20)
for the margin location.
printed result is the same as
when "OFF" is selected.
).