Selecting The Vertical And Horizontal Copy Ratios Separately (Xy Zoom Copying) - Sharp AR-M161 Operation Manual

SELECTING THE VERTICAL AND
HORIZONTAL COPY RATIOS SEPARATELY
Separate ratio settings can be selected for the length and width of a copy.
Example: Reduction only in the horizontal direction
• This feature cannot be used with the 2 in 1 / 4 in 1 feature or card shot feature (when the dual function board is
installed).
• To use the XY zoom feature and the dual page copy feature simultaneously, set the dual page copy feature first
and then the XY zoom feature. (Enlargement cannot be set.)
• If automatic ratio selection has been selected, the XY zoom feature cannot be selected. If the XY zoom feature is
selected, automatic ratio selection cannot be selected.
• Ratios that can be selected are 25% to 400% (50% to 200% when the SPF is used).
1
Place the original in the document
feeder tray or on the document glass.
2
Press the [SPECIAL FUNCTION] key.
2-SIDED
COPY
SPECIAL FUNCTION
DUPLEX SCAN
ACC.
The special function
screen will appear.
3
Press the [OK] key.
BACK OK
GHI
The special modes
screen will appear.
54
Original
SPECIAL FUNCTION
SPECIAL MODES
ORIG. SIZE ENTER
PAPER SIZE SET
DISPLAY CONTRAST
SPECIAL MODES
MARGIN SHIFT
ERASE
DUAL PAGE COPY
[OK]:ADJUST
(XY zoom copying)
Copy
4
Select "XY ZOOM" with the [ ] or [ ]
key.
GH
PQR
2-SIDED
COPY
SPECIAL FUNCTION
5
Press the [OK] key.
OK
The XY zoom screen will appear, ready for selection of
the X (horizontal) ratio.
6
Set the horizontal ratio with the [ ],
[ ], [ ], or [ ] keys.
A preset ratio can be selected
with the [
ratio can be adjusted in
increments of 1% with the [
or [
SPECIAL MODES
DUAL PAGE COPY
2in1/4in1
XY ZOOM
[OK]:ADJUST
XY ZOOM
115% ZOOM
100% X: 100%
86% Y: 100%
[ ]:X Y
] or [ ] keys. The
] keys.
]