Table of Contents
Advertisement
After recording:
Press the /:OFF button whilst in the stop
mode.
After the track number has been written
on the disc, the power will shut off auto-
matically. (For details about the TOC,
see page 19.)
To remove the MiniDisc:
Turn off the power and move the OPEN
lever in the direction indicated by the arrow.
2
1
OPEN
3
Recordings can not be made in the
following situations:
Recording on a playback-only MiniDisc
(commercially available music)
If a MiniDisc is protected against acci-
dental erasure (page 8)
About the recording level:
If the recording level is too low, the play-
back sound volume may be too low to
hear well. If it is too high, the playback
sound may be greatly distorted. Since
digitally recorded CDs have a large dy-
namic range (the volume can vary tre-
mendously from very soft to extremely
loud), do not set the recording level any
higher than is necessary.
Precautions when recording:
Do not jar or bump the main unit whilst
recording. Otherwise, the recording
may be unusable.
Recording from a tuner or a CD
(Manual recording)
Manual recordings can be started and
stopped as you like.
1
Place the unit in the recording stand-by
mode. (Perform steps 1 - 4 in the "Syn-
chro recording" section.)
2
Press the 06 button.
Recording will start.
To record from a CD, press the 06
button, and then start playback on the
equipment connected to this unit.
Track numbers can be created whilst
recording. (Page 16)
To interrupt recording:
Press the 06 button whilst recording.
The unit will enter the recording stand-
by mode.
To resume recording, press the 06 but-
ton again.
The track number will be increased by
one each time you interrupt a record-
ing.
Depending on the strength and type of
playback signal in the original record-
ing, the new recording may not begin
or pause at the correct point when in
the synchro mode. If this happens, try
making a manual recording.
Precautions when inserting a MiniDisc:
To insert a MiniDisc, push on the middle
of the edge of the disc whilst holding it
parallel to the main unit.
If any resistance is felt, do not try to
force the MiniDisc into the unit. It may
additional more problems. If resistance
is felt, remove the MiniDisc and try re-
loading it.
Notes:
Whenever any button is pressed, the
remote control display will light for ap-
proximately 7 seconds.
The REC button does not light.
E-10
Advertisement
Table of Contents
