Epson EMP-TW100 User Manual page 42

When the Indicators Provide No Help
The display mode (aspect ratio ) setting
may not be selected correctly.
Has the "Position" setting been adjusted
correctly?
Has the correct resolution been selected?
Change the resolution for the laptop
computer or computer with a LCD screen.
Has the computer been set for dual display?
Are the cables connected correctly?
Has the image contrast
correctly?
Has the color been adjusted correctly?
Have the color intensity and tint been
adjusted correctly?
(The colors may not exactly match the colors in the
image on the computer screen or LCD screen, but this
is normal and is not the sign of a problem.)
Is the lamp due for replacement?
If the
lamp will soon be due for replacement. When the lamp
is nearly due for replacement, the image will become
darker and the tint will become poorer.
Does the input signal setting match the
connected source?
40
Probable cause
Probable cause
been adjusted
indicator is flashing orange, it means that the
Condition
Image is too large (Only part of the image is displayed)
Image is too small
Press the [Aspect] button on either the remote control
or the projector's control panel. (p.14)
Use the "Position" command in the "Advanced" menu
to adjust. (p.29)
Set the computer so that the signals that are output are
compatible with this projector. Refer to the
documentation provided with your computer for details
on changing the settings. (p.50)
Change the resolution so that the image is displayed in
the whole of the projection area, or set the image signal
to external output only. (p.7)
If dual display has been activated in the "Display
Properties" of the computer's "Control Panel", the
projector will only project about half of the image on
the computer screen. To display the whole of the image
on the computer screen, turn off the dual display
setting. Refer to the video driver manual for the
computer's monitor for further details.
Condition
The image colors are not right
Check that all cables that are required for projection are
connected correctly. (Setup Guide)
Use the "White Level" command in the "Video" menu
to adjust the contrast.
"Video" - "White Level" (p.25, 27)
Use the "Color Adjustment" command in the "Video"
menu to adjust the contrast.
"Video" - "Color Adjustment" (p.26, 28)
Use the "Video" menu to adjust the "Color" and "Tint"
settings
"Video" - "Color", "Tint" (p.25)
Replace the lamp with a new one. (p.46, 47)
Use the "Video Signal", "Input A" or "Input B"
commands in the "Advanced" menu to select the signal
format that matches the connected source.
"Advanced" - "Video Signal", "Input A", "Input B" (p.29)
Remedy
Remedy