Saving And Retrieving Image Quality Settings (Memory); Saving Settings - Epson EMP-TW100 User Manual

Functions for Enhancing Projection

Saving and Retrieving Image Quality Settings (Memory)

Up to a maximum of six adjustment values in the "Video" and "Advanced" menus can be memorize per input
source, and settings for six different sources can be recorded, for a total of 36 possible settings. You can save
the adjustment values for particular video scenes, and then use the memory button on the remote control to
retrieve these settings at a single touch. (p.26, 28)
The following adjustment values can be stored in memory.
Video menu:
Black Level, White Level, Sharpness, Color, Tint, Color Mode, Color Adjustment
Advanced menu:
Progressive, Motion Detect, Noise Reduction, Setup Level
Aspect ratio setting
This is the aspect ratio that is selected using the [Aspect] button on the projector's control panel or the remote
control.

Saving Settings

Procedure
1
2
3
4
22
Projector
Remote control
Video Black Level
0 -
Advanced White Level 0 -
Sharpness 0 -
Setting
About Color 0 -
Tint
Reset All 0 -
Color Mode
Select
Color Adjustment
Color Temp. RGB
Memory 1 2 3 4
Reset Execute
Select Enter
Video Black Level
0 -
Advanced White Level 0 -
Sharpness
Setting 0 -
Color
About 0 -
Reset All Tint 0 -
Color Mode Select
Color Adjustment
Color Temp. RGB
Memory
1 2 3 4
Reset Execute
Return Select Adjust
Projector
Remote control
Press the [Menu] button on either the
projector's control panel or the remote
control.
The environment setting menu will be displayed,
with the adjustment values appearing as are
currently set.
Select "Memory" from the "Video" sub-
+
menu.
+
+
If using the projector's control panel, press the
+
+
and buttons.
Adjust
If using the remote control, tilt the [Select] button
5 6
up and down.
Select the memory number (1 - 6) to use
+
for saving the settings.
+
+
If using the projector's control panel, press the
+
+
and buttons.
Adjust
If using the remote control, tilt the [Select] button
5 6
to the left and right.
The numbers correspond to memory buttons [1]
to [6] on the remote control.
Confirm the memory setting.
Press the [Select] button on either the projector's
control panel or the remote control.