When The Indicators Provide No Help - Epson EMP-TW100 User Manual

When the Indicators Provide No Help

If any of the following problems occur and the indicators do not offer a solution, refer to the pages given for
each problem.
No images appear
Poor image quality
Only part of the image is displayed (Large/small) p.40
The image colors are not right
Is the lens cover still attached?
Is the power cord disconnected?
Is the main power switch turned off?
Was the power turned off and then straight
back on again?
While the indicator is flashing orange (during cool-
down ), the [Power] button on eiher the remote
control or the projector's control panel will not operate.
Have you pressed the [Power] button on
either the remote control or the projector's
control panel?
Is sleep mode active?
When sleep mode has been set to "ON", the lamp turns
off automatically if no operations are carried out for a
set period of time while no video signal is being input.
The indicator lights orange at this time.
Is blank mode active?
Is the projected image completely black?
Some input images, such as screen savers, may be
completely black.
Is a image signal being input?
If "No-Signal Msg." in the "Setting" menu has been set
to "OFF", no messages will be displayed.
Try resetting all of the current settings.
Probable cause
p.37, p.38 Images appear dark
p.39 Images appear green
The remote control does not work p.41
p.40 The power does not turn off
Condition
No images appear (Nothing at all appears)
Remove the lens cover. (p.6)
Check the power cable connection at the power inlet of
the projector and at the wall outlet. (p.6)
Turn on the main power switch at the rear of the
projector. (p.6)
Wait until cool-down has finished. You can then use the
[Power] button on either the remote control or the
projector's control panel. (p.8)
Press the [Power] button on either the remote control or
the projector's control panel. (p.7)
Turn the projector power back on. To cancel the sleep
mode setting, set "Sleep Mode" in the "Setting" menu
to "OFF".
"Setting" - "Sleep Mode" (p.30)
Press the [Blank] button on the remote control to cancel
the blank function.
"Setting" - "Blank" (p.30)
Cancel the screen saver, or re-check the images being
input.
Change the "No-Signal Msg." setting to "Black" or
"Blue" for messages to be displayed.
"Setting" - "
No-Signal Msg."
If a message is displayed, refer to the item indicated.
"Reset All" (p.32)
p.41
p.41
p.42
Remedy
(p.30)
37