Crosley CFD28WIS3 Use & Care Manual page 6

French door bottom freezer
Table of Contents

Advertisement

Leveling Freezer Drawer (ifnecessa ) Level Refrigerator & Adjust Doors
(if necessary)
DO NOT remove center screw from freezer drawer.
Th!s is a factory adjustment: ........................................................................................................................................................................
To level the cabinet using the front
rollers (select
models):
1
Slightly open freezer drawer. Lift the toe grille and
gently pull forward (see illustration).
_F_k_
Toe Grille Must __
/
__ I
"_
Fit In Slot On
/
II ._
(
_
1
AnU,tipBracket
(
_il
\
.) i_._ 1,_
Screw/Washer
_I
r _!_ _
\/'_
I_y
Assembly
_@
\./q
\#'!
2
3
4
Check gasket sea! around top, bottom, and sides of
freezer drawer.
If gasket is not sealed, open drawer and slightly
loosen four (4) drawer screws (two (2) on each
side) to allow drawer to rotate.
Head
Drawer
__
Head
Drawer
Screw
Screw
Remove Hex
Remove Hex
Head Drawer
Head Drawer
Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B).
Push
Freezer
Drawer
i
Be careful not to rotate the drawer.
CCCCCCCCCCCCCI:I',
' iili
S Tighten four (4) drawer screws.
6
Recheck gasket sea!.
7
Install the toe grille by fitting into place.
Guidelines for final
positioning of your refrigerator:
*
All four corners of the cabinet must rest firmly on
the floor.
The sides should tilt _/4inch (6 mm) from front to
back (to ensure that doors close and seal properly).
Doors should align with each other and be level.
Host of these conditions
can be met by raising
or
lowering
the adjustable
front
rollers,
To level the cabinet using the front
rollers:
1 You can raise or lower each door. use a 3/8 inch
socket wrench to turn the adjustment screws (1
per side).
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw counterclockwise.
2
Ensure both doors are bind-free with their seals
touching the cabinet on all four sides and that
cabinet is stable.
3
After unit is leveled, lower antFtip leg until it
contacts the floor.
o
o
Door
o
o
o
o
Door
oo

Advertisement

Table of Contents
loading

Table of Contents