Lamp Indicator; Temperature Indicator - Epson EMP EMP-9100 Owner's Manual

Indicator Status
Extinguished

Lamp Indicator

Indicator Status
Blinking in Red
Blinking in
Orange
Extinguished

Temperature Indicator

Indicator Status
Illuminated in
Red
Blinking in Red
Cause
The power is not The power is not switched on.
switched on · Check to ensure that the lamp or fan are
correctly attached if the lamp has been
replaced. If the lamp or fan are not correctly
attached, the projector will assume the same
status as if the power has not been switched
on.
· Check the power cord connection.
Check the power supply to the socket.
Cause
Lamp error · Replace with a new lamp (ELPLP11).
· If the lamp is broken, take care to avoid injury
and contact your nearest adress provided at
page 104 to request repairs (images cannot be
projected unless the lamp is replaced).
Nearing the time Prepare a new lamp. It is recommended that
for replacing the the lamp is replaced as soon as possible, as
lamp there are cases where the time for replacement
is earlier than stated in the conditions of usage.
(Not an error)
The power has not been switched on or nor-
mal projection is in progress.
Cause
Excesive internal · Use the projector within the permissible
temperature temperature range of between 5 degrees
(overheating) Celsius and 40 degrees Celsius.
· Install the projector in a well-ventilated place
and ensure that the ventilation inlet and
outlet are not blocked.
· Clean the Air Filter.
· Switch the lamp off when the red lamp is
illuminated to reduce the temperature inside
the projector.
Internal error Cease operations, remove the Power Plug
from the socket and contact your dealer or
nearest adress provided at page 104 and
request repairs.
Recovery or Status
Recovery and Status
Recovery and Status
Troubleshooting - 79
Reference
Page
39
Reference
Page
91
91
Reference
Page
22
89