Ending - Epson EMP EMP-9100 Owner's Manual

Ending

End projection in accordance with the following procedure.
1
Press the [Power] button.
A message to confirm that the power needs to be switched off will be displayed.
Power
Computer
Power
A/V mute
Resize
2
Press the [Power] button once more.
The lamp will be extinguished, the Operation Indicator will blink in orange, and the cool-
down process will commence.
(Power OFF?)
Please press
to power off.
Power
Computer
Power
A/V mute
Resize
The Operation Indicator will change from blinking to being illuminated in orange once the
cool-down process has been completed. The amount of time required for the cool down is
approximately forty seconds (may be longer depending on the ambient temperature).
Point
· Press a different button if the power is not to be switched off. The message will be erased
after seven seconds if no buttons are pressed (the power will remain on).
· It is also possible to end projection by pressing the [Power] button as explained in proce-
dure #1 for more than one second (will assume the same status as if ending with proce-
dure #2).
· Button operations are not possible when the Operation Indicator is blinking in orange. In
this event, please wait until full illumination has been attained.
Menu
Esc
Help
Video
Keystone
Volume
Shift
Power
Menu
Esc
Help
Video
Keystone
Volume
Shift
Power
Freeze
Power
A/V Mute
R/C ON
E-Zoom
OFF
3
Enter
Esc
Key again
Power
Freeze
Power
A/V Mute
R/C ON
E-Zoom
OFF
3
Enter
Esc
Ending - 43