Problem Solving
Problems when projection starts
f
f
Power does not turn on
Check
Did you press the [t] button?
Are the indicators switched off?
Do the indicators turn on and off when the power cable is
touched?
Is the Control Panel Lock set to "Full Lock"?
Is the correct setting for the remote receiver selected?
Press the t button to turn the power on.
The power cable is not connected correctly or power is not being supplied normally.
Disconnect and then reconnect the power cable. s Quick Start Guide
Check that your electrical outlet or power source is functioning correctly.
Check that the lamp cover is securely installed.
There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power
cable. If this does not solve the problem, stop using the projector, disconnect the power cable from the
electrical outlet, and contact your local dealer or the nearest address provided in the Support and Service
Guide. s
Epson Projector Contact List
Press the [t] button on the remote control. If you do not want to use "Control Panel Lock", change the
setting to "Off". s "Settings" - "Control Panel Lock"
Check the "Remote Receiver" from the configuration menu. s "Settings" - "Remote receiver"
Remedy
p.35
72
p.43