Setting The Projector Id; Setting The Projector Id On The Remote Control - Epson EB 1735W User Manual

Restrictions in the Target Projector when Using Multiple Projectors

Setting the Projector ID

Procedure
A
During projection, press the [Menu] button on the
projector and select "Extended" - "Projector ID"
from the configuration menu. s "Using the
Configuration Menu"
Using the remote control
B
Choose the ID you want to set and press the [Enter]
button.
C
Press the [Menu] button to close the configuration
menu.
p.38
Using the control panel

Setting the Projector ID on the Remote Control

Set the ID on the remote control each time you switch the projector power
on.
Procedure
During projection, point the remote control at the remote
receiver of the target projector. When you press the [ID]
button on the remote control, the projector ID and remote
control operation On/Off display is shown at the top right
of the projection screen.
When remote control operations are
enabled:
When the display reads Off
While holding the [ID] button, press a number button to
select a number to match the ID of the projector you want
to operate.
Once this setting has been made, the projector that can be operated by the
remote control is limited.
Keep pressed
30