note
If
is
Direct Power On
enabled, the power cord is
connected, and a power
outage occurs, the projector
will start when the power is
restored.
note
Do not use the projector at
altitudes above 7,500 feet
(2,286 meters).
Using the Projector Menus
72
■
Operation
Direct Power On:
projector when you connect the power cord (without pressing the
Ppower button).
: Enable if you want the projector to turn off
Sleep Mode
automatically if it is idle and no signal is received for 1 to 30
minutes (you can adjust the amount of time using the next
setting).
Sleep Mode Timer
period of time before the projector turns off automatically, from
1 to 30 minutes.
High Altitude Mode
above 4,900 feet (1,500 meters) to ensure that the temperature is
regulated properly. Turn this setting off for lower elevations.
Select a specific audio input source or set to
Audio Input:
to support any input source.
■
Standby Setup
: Select
Standby Mode
projector to be monitored and controlled from a computer when
it is in standby mode (the power light is orange). This setting also
allows you to use a microphone connected to the projector or to
run audio through the projector in standby mode.
Standby Microphone
microphone when the projector is in standby mode.
: Enable this setting to output audio when the
Standby Audio
projector is in standby mode.
■
USB Type B
Select how you want to use the
Select
USB Display
images. Select
Wireless Mouse
buttons like a wireless mouse. See page 58 for restrictions and
details.
Enable if you want to be able to start the
: When Sleep Mode is on, you can set the
: Enable when you are using the projector
Communication On
: Enable this setting to use a connected
TypeB
to use the USB port to project computer
to use the remote control
Auto
to enable the
(square) USB port.