Input Select - Yamaha DSP-Z11 Owner's Manual

Decoder parameter
Dimension
("PLIIx Music" and "PLII Music"
only)
Center Image
("Neo:6 Music" only)
■
(Program parameters initialization)
Initialize
Use this feature to initialize the parameter of the selected sound field program.
Choices: No, Yes
• Select "Yes" and then press 9ENTER to set the program parameters to the factory default settings.
• Select "No" (or press 9l) to cancel the program parameter initialization.
y
Use "DSP PARAM" of "INITIALIZE" in "Advanced setup" to initialize the parameters of all sound field programs (see page 120).

Input Select

Use this feature to reassign digital input/outputs, select the input
signal, rename the inputs, or adjust the level of the signal input at
each input source.
Input source Sub input source
TUNER
—
MULTI CH
—
PHONO
CD
CD-R
MD/TAPE
BD/HD DVD
—
DVD
DTV
CBL/SAT
DVR
VCR
V-AUX
—
DOCK
—
NET/USB PC/MCX
NET RADIO
USB
Pro Logic IIx Music and Pro Logic II Music dimension. Adjusts the sound field either towards the front or towards the rear.
Control range: –3 (towards the rear) to +3 (towards the front)
Initial setting: STD (standard)
DTS Neo:6 Music center image. Adjusts the front left and right channel output relative to the center channel to make the
center channel more or less dominant as necessary.
Control range: 0.0 (center channel sound is output only from the front left and right speakers) to
1.0 (center channel sound output only from the center speaker)
Initial setting: 0.3
Rev. Level
Dialogue Lift
Initialize
Parameter
Volume Trim
Rename
Volume Trim
Rename
Multi CH Assign
BGV
I/O Assignment
Audio Select
Decoder Mode
Volume Trim
Rename
I/O Assignment
Audio Select
Decoder Mode
Volume Trim
Rename
Volume Trim
Rename
Volume Trim
Play Style
Volume Trim
USB Select
Volume Trim
Play Style
Features
No
Yes
Notes
• Some parameters described above may not be available for all input sources and some
parameters are only available for specific input sources.
• You can set "Volume Trim" for each sub input source separately.
• The "Play Style" setting is effective to both "PC/MCX" and"USB".
■ I/O Assignment
(Input/output assignment)
Use this feature to assign the input/output jacks according to the
component to be used if the initial settings of this unit do not
correspond to your needs. Change the following parameters to
reassign the respective jacks and effectively connect more
components.
Once the input/output jacks are reassigned, you can select the
corresponding component by using the D INPUT selector (or the
input selector buttons (3)).
I/O Assignment
Audio Select
Decoder Mode
Example 1: Assigning the CD DIGITAL INPUT COAXIAL
jack to "VCR".
1
Select "Input Select" in the GUI menu and then select
"VCR".
2
Select "I/O Assignment" and then "Coaxial Input".
3
Select " 5 CD".
Graphical user interface (GUI) menu
Coaxial Input
Optical Input
Optical Output
81
En