■ Using REMOTE IN/OUT and TRIGGER OUT jacks for Zone 2, Zone 3, and Zone 4
You can use the REMOTE IN/OUT and TRIGGER OUT jacks on this unit for Zone 2, Zone 3, and Zone 4 as well as the main zone. Refer to
"Using REMOTE IN/OUT jacks" and "Using the TRIGGER OUT jacks" on page 36 for more information.
REMOTE IN/OUT jacks
This unit is equipped with two REMOTE IN and REMOTE OUT jacks. You can use the REMOTE IN/OUT jacks to control this unit or other
component from Zone 2, Zone 3, or Zone 4.
The following diagram shows an example of the connections.
DVD player (etc.)
CD player (etc.)
y
Some Yamaha models are able to connect directly to the REMOTE OUT jack on this unit. If you own these products, you may not need to use an infrared emitter. Up to six Yamaha
components can be connected as shown.
REMOTE
Infrared signal
receiver
TRIGGER OUT jacks
This unit is equipped with two TRIGGER OUT jacks. You can turn on and off the component corresponding to the selection of the input
source of the desired zone or turning on and off the desired zone. Use "Trigger Output" in "Manual Setup" to set the functions of the