Macro Programming Features; Recalling Programmed Macro-Operations - Yamaha DSP-Z11 Owner's Manual

5
Press 9ENTER.
The edit screen of the name of the currently selected control
area appears in the display window (4).
BD/HD
6
Press 9l / h repeatedly to move the cursor (_) to
the position you want to edit.
7
Press 9k / n repeatedly to select and enter the
desired character.
Pressing 9k changes the character as follows:
A to Z, a to z, 0, 1 to 9, space, - (minus), + (plus), / (slash) and
: (colon).
y
Pressing 9n changes the characters in reverse order.
8
Repeat steps 6 and 7 until you change all the letters
you want.
9
Press 9ENTER to set the new name.
"OK" appears in the display window (4) on the remote
control if renaming was successful.
y
When you want to rename the another name of the selected control area, press the
(3) or 5SELECT l / h repeatedly to select the
input selector button
desired control area and then press 9ENTER and then carry out the operations
of steps 4 through 9.
Press G SETUP again to exit the setup menu.
10
The new name of the control area appears in the display
window (4).
HDDVD
Note
"ERROR" appears in the display window (4) on the remote control if you press a
button not indicated in the respective step, or when you press more than one button
simultaneously.

Macro programming features

The macro programming feature makes it possible to perform a
series of operations with the press of a single button. For example,
when you want to play a CD, normally you would turn on the
components, select the CD input, and press the play button to start
playback. The macro programming feature lets you perform all of
these operations simply by pressing the CD macro button. The
buttons listed as macro buttons below are factory set with macro
programs. You can also program your own macros (see page 108).

■ Recalling programmed macro-operations

POWER POWER STANDBY POWER
TV AV
MD
MULTI V-AUX PHONO
TAPE
BD
DVD CD CD-R
HD DVD
CBL
DTV DVR VCR
SAT
NET
TUNER DOCK
USB
AMP
TV
SOURCE
SELECT MACRO
SETUP ID
MODE ZONE
SYSTEM MEMORY
1 2 3 4
1
Press HMACRO on the remote control.
MACRO
2
Press the desired macro button.
"M:the 3-letter name of the selected control area" (for
example, "M:DVD") appears in the display window (4), and
this unit transmits the programmed functions. When you press
DSTANDBY or EPOWER, "M:STB" or "M:PWR" appears
in the display window (4), and this unit transmits the
programmed functions.
3
Press HMACRO again to exit from the macro-
operation mode.
Notes
• While the remote control is running a macro program, it does not accept any other
operation until it has completed running the program (the transmission indicator in
the display stops flashing).
• Continue to aim the remote control at the component the macro is operating until the
macro operation is complete.
• If you do not complete each of the operations within 30 seconds, this unit
automatically exits from the macro-operation mode.
Remote control features
Macro buttons
MACRO
107
En